BA 6, BA 13 ... glued
Covering by BA 6, BA 13 .... glued to masonry, concrete (wall, post, beam ...).
Wedges are placed on the ground, in order to reserve a foot
space of the order of 1 cm. Cut the plate, put the studs
glue on the plate or on the wall. Install BA 6, BA 13 ...
against the wall, the panel must be up against the ceiling and
finish typing it with a two-meter ruler for flatness.
Adhesive mortar map.
To glue and fill the holes
As for a polystyrene plate, ten spots of adhesive mortar per M².
The studs will be placed 10cm from the edges,
This process allows cladding on all types of rough walls in concrete, masonry, brick and on plasterboard already installed (on lining plate, alveolar partition, plasterboard partition, hydro, plaster tile, BA 6, BA 13 .. ...) gluing is a quick and easy application
Depending on the specifics of the site, several possibilities are offered:
On old paint, plaster, upholstery, they are removed at the location where the glue spots are provided by scraping (5mm deep and 15cm wide) or sanding.
Impregnate the wall with a first pass of adhesive mortar (map)
On siporex, impregnate the wall with a first pass of adhesive mortar
using a spatula or knife at the location where the
plots.
Old walls: strip, dust and apply the glue spots
directly on the wall (and not on the plate).
Do not wet the support before installation.