Making a bar
For a bar. Same system as for a placostil partition, but the height is approximately 1.00 m.
Rail
Amount
BA 13
Make a small return to solidify everything then screw a board from below before closing the partition. All of course level!
Fix the rails to the ground, fix the first upright against the wall, make the framework.
Screw the plank from below, close the partition, jointed.
Put the plates on one side (inside).
Cap
For a cap. Same system as for the bar but upside down, the height is approximately 60 cm, for a ceiling of 2.50 m.
Secure the rails to the ceiling (screw or plug every 30cm)
make the framework.
Put the plates on one side (inside).
Screw the board over, close the partition, jointed.
Applied
Making an applique, nothing could be simpler. Fix the 15cm uprights against the wall with 25mm screws on plasterboard, fix the BA13 of
each side (15 by 10) and to finish, cut a piece of BA13 (60x 60) or another rib ^^, fix as best as possible to the axis, plug the holes and finally,
upholster or paint.
Top view
Rear view
Niche
Make a recess (niche) in a wall with the gap behind, which can accommodate a statue, a piece of furniture, etc. (on placostil).
Rail
Rising
BA 13